Laser cut texture mats featuring my own original designs.
The artwork design makes OUTIE (Protruding) lines / pattern in the clay. The circles and lines will stick out of the molded part.
Inspired by the fabric pattern in an antique wing-back chair; swirls and leaves run rampant in this timeless design. The all-over pattern can be used as a background. Or, select an individual section of swirls or leaves for a small area or item.
How to Use with polymer clay:
Make a sheet of clay, second or third thickness on a pasta machine. (about the thickness of a round toothpick) Lightly mist the mat and place the mat onto the sheet of clay. Using a polymer clay roller or brayer press firmly, starting in the middle of the sheet, and roll the roller away from you. Then put the roller back in the center of the mat and roll toward you, pressing the mat into the clay.
Other ways to imprint clay, lay the mat down and put the clay sheet on top of the design mist with water. Imprint the clay using a roller on the clay as above from the center out or press the clay into the design using your fingers. Press firmly from one side to the other while moving your fingers forward a bit until the entire sheet of clay has been firmly pressed into the clay. Remove carefully and use as desired.
This laser cut mat is for use with polymer clay, metal clay, etc.
We do NOT recommend this mat for use in a Pasta Machine.
Not for use with FOOD.
These Flexible Texture Mats are Approx. 5.5 by 3.675 inches. (14 by 9.75 cm) Over 20 square inches!